Problem
Cause
Remedy
Drill press will
not start
Power cord not
connected to the
mains power supply
Ensure that the power cord is
connected to the mains power
Power fault
Check the mains power
supply
Power cord
damage
Use an authorised service
centre to repair or replace
Faulty switch or
motor
Use an authorised service
centre to repair or replace
Pulley cover not
secured
Check the pulley cover is
closed and lowered correctly
in position
Noisy operation Incorrect belt
tension
Adjust tension as required
Drill bit burns
Incorrect speed
Adjust speed as described in
the “
Changing the speed
”
section
Excessive drill
bit wobble
Bent or damaged
drill bit
Use a new drill bit
Drill bit is not
securely placed in
the 13mm keyed
chuck
Remove the drill bit and
reinsert correctly, ensure the
chuck jaws are fully tightened
The 13mm keyed
chuck is not
installed correctly
Ensure you install the 13mm
keyed chuck correctly
Drill bit binds in
workpiece
Belt tension is set
incorrectly
Re-adjust the belt tension
DESCRIPTION OF SYMBOLS
SPARE PARTS
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
/min
Revolutions or
reciprocation per minute
n
o
No load speed
Hp
Horse power
Warning
Use eye protection
WARNING!
FAILURE TO UNPLUG YOUR DRILL
PRESS COULD RESULT IN ACCIDENTAL STARTING
CAUSING POSSIBLE SERIOUS PERSONAL INJURY.
TROUBLESHOOTING
Spare parts can be ordered from the Special Orders
Desk at your local Bunnings Warehouse or Homebase
store.
For further information, or any parts visit
www.ozito-diy.co.uk or contact Ozito Customer Service:
Great Britain: 0151 294 4488
Ireland: 1850 882711
E-mail: [email protected]
