Installing and removing drill bits
1. Using the chuck key, loosen the
jaws of the chuck by rotating in an
anti-clockwise direction.
2. Insert the drill bit fully into the
13mm keyed chuck.
3. Whilst holding the drill bit in one
hand, rotate the top collar of the
13mm keyed chuck in a clockwise
direction.
Ensure that you tighten all 3 holes
in the 13mm keyed chuck using the
chuck key to securely tighten the
jaws and hold the drill bit in position.
6. To fit the feed wheel handles,
screw them into the feed
wheel hub.
7. To fit the 13mm keyed chuck,
first place a piece of timber on
the table and position the 13mm
keyed chuck with the jaws
retracted under the drive shaft.
Raise the table toward the drive
shaft until the 13mm keyed chuck
is approximately 25mm from the
drive shaft.
8. To secure the 13mm keyed chuck to the
drive shaft gently lower the drive shaft
using the feed wheel handles until the
drive shaft is pushed into the rear of the
13mm keyed chuck. A gentle tap on the
timber is required to secure the 13mm
keyed chuck onto the tapered drive shaft.
9. Fit the pulley cover knob to the
pulley cover by using the pulley
cover knob assembly (supplied).
0
10
20
30
40
50
0
10
20
30
40
50
Approx. 25mm
