3. MIXING BLADE ASSEMBLY
2. DRUM ASSEMBLY
2. With the help of a second
person, carefully set the lower
drum onto the side supports
of the frame assembly. Ensure
the large diameter shaft is
at the support leg end of the
stand
6. Position the upper drum over
the rim of the lower drum.
Ensure that all the mounting
holes align as well as the
arrows on either side of the
rim.
4. Align the Rubber Gasket with
the holes and screw heads on
the lower drum.
Note:
Ensure the Rubber Gasket
is not twisted and flat on the lower
drum.
Shaft
1. Use assembly
fasteners bag
5. Use assembly
fasteners bag
3. Secure the lower drum
to the frame assembly by
inserting the M8x55 bolts
with washers into the side
supports and secure with
the nuts. Tighten with 13
& 14mm spanners (not
supplied).
7. Insert the M8x20 bolts, spring
washers and flat washers into
each of the mounting holes in
the rim. Secure each bolt with
14mm spanner (not supplied).
2. Insert 2 M8x20 bolts and washers into the upper and lower drum
from the outside. Place the rubber washer, thin washer onto the bolt
followed by the end of the mixing blade and secure with thin washer
and nut.
2
4
2
2
2
6
4
M8 55
M8 65
M8 60
M8 20
M8 20
M8 30
M8 20
1
M10 70
2
10
2
4
M8 16
1
1
2
M8 25
4
4
4
8
Bolt
Thin Washer
Nut
Rubber Washer
Washer
B
C
D
Hole
Screw Head
2
4
2
2
2
6
4
M8 55
M8 65
M8 60
M8 20
M8 20
M8 30
M8 20
1
M10 70
2
10
2
4
M8 16
1
1
2
M8 25
4
4
4
8
1. Use assembly
fasteners bag
2
4
2
2
2
6
4
M8 55
M8 65
M8 60
M8 20
M8 20
M8 30
M8 20
1
M10 70
2
10
2
4
M8 16
1
1
2
M8 25
4
4
4
8
3. Repeat step 2 for the second mixing blade. Then ensure both ends
of the mixing blades are tight.
Note:
Position the mixing blade inside the drum assembly with the
pointed end facing downward.
