![background image](http://html.mh-extra.com/html/ozito/cmx-080/cmx-080_operation-manual_1666473012.webp)
OPERATION (cont.)
11
Turning the Cement Mixer On and Off
•
To turn the cement mixer on, press the green button.
•
To turn the cement mixer off, press the red button.
Loading the drum
IMPORTANT:
Completely unwind an extension cord (not supplied). Connect it to
the cement mixer first before connecting to a power supply.
IMPORTANT:
Always start the cement mixer before loading the drum assembly
(1). Load the drum assembly (1) while it’s rotating.
IMPORTANT:
Ensure material is not loaded into the cement mixer all at once. Add
the material steadily over the mixing blades (12), this helps to avoid the material
from sticking to the back of the drum assembly (1).
For best loading results, proceed as follows:
•
Add the required amount of stone into the drum assembly (1).
• Add the required amount of sand into the drum assembly (1).
•
Add the required amount of cement into the drum assembly (1).
•
Pour the required amount of water into the drum assembly (1).
Warnings:
1.
Do not let the shovel mouth or any other devices enter the drum mouth
during loading.
2.
Never place hands inside the revolving drum.
3.
Place the cement mixer as close as possible to the work site. Do not
move the cement mixer when loaded.
4.
Retighten all bolts attaching motor and motor housing assembly (2),
drum assembly (1) and frame assembly (5) after first mix.
Note:
When measuring out cement and ballast (or sharp sand/gravel), use a small
bucket to ensure accurate ratios of cement: ballast. Refer to the instructions that
come with your cement.
Ensure your chosen quantity of concrete is large enough that the cement mixer will
function and small enough that it will fit in the drum assembly (1), see load sizes in
specifications section of manual to calculate quantities.
1. Turn the cement mixer on.
2. Add approximately half the ballast (or half the sand and half the gravel) required.
3. Add a small amount of water and allow it to wash around with the ballast for a
minute or two.
4. Add all the required cement.
5. Add the remaining ballast/sand/gravel and allow it to mix for a minute or two.
Summary of Contents for CMX-080
Page 1: ......