OZGENC MAKINA OMRM 113, Operation Manual

Page: 20 / 110

OMRM 113 User Manual
22 | P a g e
6.4 General Safety Rules
OMR 113 Double Head Cutting machine is suitable for only one single operator. Operator must
not operate the machine in case of any lack of attention caused by drugs, alcohol or medication.
Operator must check the machine and components prior to operation. It should be ensured that
the main switch is turned off during routine maintenance. Power and pneumatics must also be
switched off. Any pressure must be discharged in case any hydro-pneumatic equipment is used.
Do not replace the equipment and safety parts on the machine. Do not lift the safety device
and barriers. Operator must wear a uniform suitable for machine and manufacturing
requirements. Operator must not wear any rings, bracelets etc. which may cause an accident.
Employees with long hair must use hair nets, if necessary. The machine must be installed in
accordance with the training provided by M.S.K.
6.5 Maintenance Measures for Safety
All maintenance procedures must be performed by expert technicians who have command over
the periodical technique. Use predefined equipment for machine maintenance.
6.6 Electrical Safety Rules
Severe occupational accidents and injuries may take place in case of failure to comply with the
following safety rules. Any electrical intervention and maintenance must be performed by an
engineer. All procedures must be performed using proper and isolated equipment. Take notice
of safety signs and do not remove them. Do not make any addition and subtraction on the
voltage line. Use original spare parts and equipment. Do not make any change in circuits. Turn
electrical hardware off prior to any cleaning procedure. Make sure that the main cabinet and
cabinet doors are closed. Cut the power from the main switch in case of fire. Use a proper fire
extinguisher.
Note: Hardware panel locks must remain in the possession of authorized staff.