The first steps
All controls are handled via the control device.
All controls are handled via the control device.
You may choose any location you like to install the control device, but please bear
in mind that it is not waterproof. You may still need to remove the protective fi lm
from the display.
The display of the control device will show the various current operating modes of
the system. We recommend that the control device is positioned in an accessible
location where it is easy to see this information.
The display is illuminated, so it is not a problem if it is installed in a very dark location.
To ensure safe and reliable operation of the system, please make sure the external unit
is in rest mode before disconnecting the control device. Check that no text is dis-
played on the control device – this is an indication that the system is in rest mode.
7
On / Off
We have produced a separate manual – the „Installation Instructions“ – which
covers the installation, wiring and initial taking into operation of your Vision
system.
In its supplied state, a search satellite for the automatic search is already confi -
gured in your Vision system‘s control unit.
A satellite swap is performed by changing the search satellite or via the DiSEqC
signals of the receiver. The signal or DiSEqC ID of the receiver must comply with
the ID list saved in the control unit of your Vision system.
See section: Satellite settings / DiSEqC ID.
Vision
