Satellite settings / DiSEqC V3-ID
This function allows you to display and edit a DiSEqC ID number from the list stored
in the Vision system‘s DiSEqC ID list.
Select a satellite and press the OK button to confi rm. The DiSEqC ID number
is displayed. At this point you can set the DiSEqC ID number that your receiver is
sending for this satellite.
Satellite settings / DiSEqC Rec-ID
Each time a programme is changed, a DiSEqC-capable receiver sends a unique DiSE-
qC ID number assigned to the satellite transmitting this programme.
You can view the DiSEqC ID sent by the receiver if you enable the function „DiSEqC
Rec-ID“ by pressing the OK button .
Now select at the receiver a programme transmitted by the specifi ed satellite. After
a short delay, this satellite‘s DiSEqC ID will be displayed at the control device.
Now you must assign this number to the same satellite in the Vision system.
Program or edit this DiSEqC ID number as described under „Satellite settings / DiSE-
qC V3-ID“.
Satellite settings / DiSEqC Data
These data are displayed after the system is switched on by pressing the OK button
and after the receiver has sent the DiSEqC signal to the Vision system.
The information is actually intended for professional users. It represents a comple-
te DiSEqC-ID transfer protocol and is displayed with four data bytes, allowing the
identifi cation of any deviations.
20
