VZR.235900.000 IG
Cube С-04 Turnstile
Installation Guidelines
15
4.2.8
Match the holes in the turnstile stands with anchors in the floor.
Check the verticality of the installation in 2 planes; where necessary, use
steel pads of the required thickness for correct installation of the turnstile.
Fix the turnstile stands using 6 screws, turning them into corresponding
anchors and using the wrench or spanner key with a nut width across flats of 10 mm.
Figure 4 - Install the side (2) and top (3) covers, the turnstile card collector
containers (1).
4.2.9
Remove the protective film from the turnstile housing.
4.3 Dismounting the product
4.3.1
Dismounting of the product when sending it for verification and
repair shall be carried out in the following manner:
1)
switch off the power supply of the product;
2)
disconnect the product from the power supply;
3)
disconnect the product’s cable part from the auxiliary cables;
4)
dismount the product from the installation site.
4.3.2 Prior to packaging, remove dust and any contaminations from the
product.
4.3.3
Pack the product into the packing box.
