14
OXE DIESEL COASTKEY MANUAL
OPERATION
Unlocking the start panel and turning on the ignition
1.
Enter the PIN code by pressing and releasing the number buttons.
The green LED indicator flashes when the correct PIN is entered, while the red LED indicator flashes if
incorrect.
2.
Within 5 seconds, press and release the
ON/OFF
button to turn on ignition.
The ignition is activated on all installed engines. The yellow LED lights and remains on to indicate that
ignition is on.
NOTE!
If the
ON/OFF
button is not pressed within 5 seconds after your PIN code is entered, the PIN code
will time out and the start panel will be locked (repeat steps 1-3).
NOTE!
When you start the engine from the remote control, no PIN code is required. The start panel
unlocks and the ignition is activated.
Features available from an unlocked start panel:
-
Start/stop of engine(s)
-
Individual start/stop of engines (multi-engine installation)
-
Trim/Tilt function (in single engine installation only)
-
Pairing the remote control (ignition is off)
-
Create new PIN code (ignition is off)
Starting and stopping engine(s) from the start panel
!
WARNING
-
Tilt the engine(s) into the water before starting the engine(s) to avoid damage.
-
If a manual kill switch is used, it must be properly installed before the engine(s) can be started.
-
The start panel must be unlocked by entering the PIN code.
-
The Kill Switch function is not enabled in this case, which is indicated by yellow flashing LED
indicator and audio signal (beeping). The audio signal will only be emitted during the first 2
minutes.
-
We always recommend unlocking the start panel using the remote control to ensure the Kill Switch
function is activated.
Starting engine(s)
1.
Press and hold the
START
button.
After h
olding for about 2 seconds, the start signal goes on to all installed engines.
2.
Release the
START
button when engine(s) have started.
A yellow flashing LED
indicator
and a beeping audio signal is indicating that kill switch function is not
enabled.
Stop engine(s) – Ignition off
1.
Press and release the
ON/OFF
button.
The engine(s) will stop and ignition is switched offf and the start panel is locked.
