NEOxl 80 Spare Chassis Replacement Instructions
10400904
©2019 Overland-Tandberg
Page 7 of 8
Aligning and Connecting the Module
Aligning the modules ensures that the robotics can move freely
between the modules.
NOTE: The library will not operate unless the alignment
mechanism is in the locked position (except the bottom module).
1.
At the back of the library, using the
alignment lock
lever
, align and lock the new module to the modules to
which it connects.
If you encounter resistance, adjust the upper module so
that the alignment mechanism pin moves into the mating
hole in the lower module.
2.
Verify that, for the
lowest
module in the library, its
alignment mechanism is in the
unlocked position
.
3.
From the front of the library, tighten the
recessed flange
screws
on the new module and the adjacent modules to
secure them all to the rack.
Reinstall Tape Drives
1.
Holding a
tape drive
by the handle and supporting it
from the bottom, position it on the alignment rails in front
of the appropriate bay.
2.
Slowly slide the tape drive into the
drive bay
until it is
flush with the rear of the library.
3.
Finger-tighten the
blue thumbscrews
to secure it.
4.
Repeat
for any additional tape drives.
Reattach Cables and Cords
1.
Reconnect the
expansion interconnect cables
(2) from
the new module to any adjacent modules.
2.
Reconnect any
Ethernet management cables
(3).
3.
Reconnect the
SAS/FC cables
(4) to any tape drives.
4.
If removed earlier, reinsert the
USB device
(5).
5.
Reconnect the
AC power cords
(1).
Reinsert Tape Cartridges
Reinstall the previously removed tape cartridges.
1.
Release and pull the
magazine
out until fully extended.
2.
Load the
tape cartridges
into the magazine in the same
location they were in previously.
Refer to the number on the assembly.
3.
Push the
magazine
slowly in by the handle until the
release latch snaps into place.
4.
Repeat
for the
other magazine
.
1
3
4
5
2
2
