7.1
Section 7: Operator Status and Indicators
Displaying the Cycle Count
The operator maintains a count of completed open/close cycles
and can display this count via an LED, in increments of 1,000
cycles.
1. To display the cycle count, press and hold the on-board Cycle
Count Key (CYC/CNT) for at least three seconds.
2. 2. The Cycle Count LED will blink rapidly, at which point
the CYC/CNT) Key may be released. The LED blinks will be
followed by a one second pause, and then the LED will blink
once per second for each 1,000 cycles the operator has
completed. Once the total cycle count has been displayed,
the LED will blink rapidly and the cycle count will displayed
again. This will continue indefinitely until user-terminated.
3. 3. To stop the cycle count display, press and hold the CYC/
CNT Key for at least three seconds. The Cycle Count LED will
go on solid for 1 second and then go out to indicate the cycle
count display has been terminated. The CYC/CNT Key may be
released at this point.
MRT Clear status indicator
If the MRT CLEAR LED is illuminated, set MRT as outlined in on
page 6.6
Timer to Close Running Status Indicator
LED will remain on solid if timer is set.
LED will flash when count down is active.
24
VA
C
(C
on
trol)
COMMONS
24VDC OUT
C
on
trol
Inputs
STOP
CLOSE
OPEN
MRT
CLEAR
CYCLE
COUNT
1-Phase
3-Phase
OVERRUN
TIMER
TIMER TO
CLOSE
CONFIGURATION OPTION SWITCHES
8 7 6 5 4 3 2 1
OFF
ON
SW401
ERR
OR
CY
CLE C
OUNT
CL
OSE LIMIT
OPEN LIMIT
MR
T CLEAR
RUNNING
TLC
CONFIGURATION OPTION SWITCHES
SW401
SWITCH POSITION
SWITCH #
ON
OFF
1
2
3
4
5
6
7
8
Momentary Close
Constant Close
Momentary Open
Constant Open
Constant Reverse
Constant Stop
1-Button
3-Button
TC 3-Strike Disable
TC 3-Strike Enable
Motor Rotation Normal
Motor Rotation Reverse
Limit Orientation Normal
Limit Orientation Reverse
Unused
Unused
MRT Status
Cycle Count
Timer to Close
Status
