13
For Help, call 1-800-784-5028 or visit www.overheaddoor.com
A Monthly:
•
Door springs and door hardware:
– Oil door rollers, bearings, and hinges using silicone
lubricant or light oil.
•
Balance Door.
– Close door.
– Release Magnetic Carriage Assembly from Rail Assembly
by pulling down on Emergency Release Knob.
– Raise door manually 3'- 4' and verify that door stays at
that position. See Check Step 2 on page 5.
–
Reattach Magnetic Carriage Assembly to Rail Assembly by
pulling the Emergency Release Knob toward Power Head.
–
Close door.
•
Contact Reverse Test.
– Perform Adjustment 2 on page 10.
NOTE
When the door is 3' - 4' above the ground, the door
should stay open. Slight movement is acceptable. If
the door moves too much, contact an Overhead Door
Distributor for service or call Customer Service at 1-800-
784-5028.
WARNING
Do not operate door automatically or manually if springs
are broken. Contact an Overhead Door Distributor for
service or call Customer Service at 1-800-784-5028.
WARNING
If the door fails to reverse on contact with the board,
adjust the Close Force Control as specified in Set Limit
Switches and Force Controls on page 20. If the Opener
still fails, contact an Overhead Door Distributor for service
or call Customer Service at 1-800-784-5028.
B Yearly:
•
Wipe off old excess lubricant from Drive Screw.
•
Lubricate Drive Screw with Lubricant (GLU-3)
NOTE
Use ONLY Lubricant (GLU-3). Other lubricants may dam-
age the Opener.
FCC AND IC CERTIFIED
All devices comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received, includ-
ing interference that may cause undesired operation.
GLU-3
Lubricant
S
CHEDULED
M
AINTENANCE
C As Needed:
•
Replace Bulbs.
