10
4
Données techniques
4.1
Caractéristiques
Plage de réglage de la
température:
5 à 35°C
Différence de température
de commutation:
environ ±1K
Tension de service:
230 V AC, 50/60Hz
Puissance:
< 2 W
Protection fusible:
3 A (ohmique)
1 A (capacitif)
Type de protection:
IP 30
4.2
Encombrements / Cotes de raccordement
Fig. 4.1 Encombrements
5
Construction et fonctionnement
5.1
Vue d’ensemble / Description du
fonctionnement
Le thermostat d’ambiance digital sert à la commande
de ventilateurs dans des installations de climatisation.
La température des ventilo-convecteurs est réglée
continuellement en actionnant un robinet à l’aide d’un
moteur. Après avoir atteint la valeur de consigne de la
température ambiante, le robinet est fermé avec le
ventilo-convecteur en marche.
Réglage de la valeur de consigne à l’aide de touches
sur un écran tactile, visualisation sur affichage digital
LCD avec rétro-éclairage bleu qui devient actif en
pressant une touche. Fonctions de service: Chauffer,
rafraîchir, ventiler. Vitesse du ventilateur: lente,
moyen, rapide ou service automatique. Réglages
mémorisables. Robinet et climatiseur commandés par
relais.
5.2
Domaine d’application
Le thermostat d’ambiance digital convient à l’opération
avec des ventilateurs à trois vitesses et sert à la
régulation de la température ambiante en combinaison
avec des moteurs tout ou rien Oventrop
(M30x1,5).
Fig. 5.1 Affichages digitaux et fonctions des touches
6
Installation et montage
6.1
Fourniture
Avant le montage, contrôler la fourniture, veiller à ce qu’elle soit
complète et ne présente pas de dommages dus au transport.
6.2
Montage
Couper l’alimentation électrique.
Attention!
Ne pas exercer de la pression sur l’affichage digital lors du montage!
Ouvrir le boîtier en repoussant les crochets clipsables sur la face
inférieure du boîtier à l’aide d’un tournevis d’une largeur d’environ 3,5
mm. Procéder au câblage selon le schéma électrique (fig. 6.1).
Ensuite, fixer le boîtier à l’aide des deux vis jointes et le fermer (fig.
6.2).
Système 2 tubes
Système 4 tubes
Fonction
de
service
Chauffer
Borne de raccordement V1
Moteur
NC
Borne de raccordement V2
Moteur
NC
Rafraîchir
Borne de raccordement V1
Moteur
NO
Borne de raccordement V1
Moteur
NC
Fig. 6.1 Schéma électrique Chauffer/Rafraîchir dans système 2/4 tubes
Fig. 6.2 Montage du thermostat