Ovention Matchbox 360, Installation And Operating Manual

Page: 15 / 20

MAINTENANCE
Form No. OVm360m-0115
15
6. Wipe all surfaces clean using a damp, non-abrasive cloth.
7. Wipe dry all surfaces using a non-abrasive, dry cloth.
8. Perform the “Daily Cleaning” procedure in this section.
Cleaning the Turntable assembly
Monthly Cleaning
1. Turn off the Standby switch and allow unit to cool. Cooling
fans will operate until the oven chamber temperature drops
below 140°F (60°C).
2. after the cooling fans shut off, disconnect the unit from the
power supply:
• For model m360-12, unplug the power cord.
• For model m360-14, move the main Disconnect switch
to the OFF (O) position.
Cleaning the air Filters
3. Remove and clean the two air filters on the back of the
oven and the single air filter underneath the control panel.
Spray and clean
each side of
turntable
assembly.
Air Filter
Temperature
High-Limit
Reset Button
Air Filter
Air Filter
Filter Bracket
To remove and clean each filter:
a. Slide the filter straight out of the filter bracket.
b. Spray the filter with water and/or soak in soap and water.
c. Rinse clean and allow the filter to air dry.
d. When the filter is dry, reinstall the filter into the filter bracket.
4. Remove both cooking racks.
5. Remove and clean the upper and lower jet plates inside the
oven chamber. To clean the jet plates:
NOTE: If side access to the oven is limited, refer to the “Front
Removal of Jet Plates” procedure in this section.
a. Turn the door latch counterclockwise to release the latch
and open the oven door so that the inside of the oven
chamber is exposed.
b. Remove both upper jet plates and both lower jet plates.
Two jets plates are situated side-by-side both above and
below the oven chamber. To remove
• Remove the outer plate by pulling the handle straight
out of the oven. Then, remove the inner plate by
reaching inside the oven, grabbing the plate, and
pulling straight out of the oven.
c. Spray Chemco Dirt Buster III Oven Cleaner onto both
sides of each jet plate. allow the cleaner to sit for 3 – 5
minutes.
d. Using a non–abrasive nylon scouring pad, apply
pressure to wipe away grease residue.
e. Wipe the jet plates clean using a damp, non-abrasive
cloth and allow to air dry. Do not reinstall at this time.
Cleaning the Jet Plates
6. Clean the visible areas of the oven chamber using the same
procedure as the jet plates (steps “c” through “e” above).
7. Reinstall both upper jet plates and both lower jet plates into
the oven chamber.
8. Close the oven door and turn the door latch clockwise to
engage and tighten the latch.
9. Perform the “Weekly Cleaning” procedure in this section.
Upper Jet
Plate,Outer
Oven
Door
Lower Jet
Plate, Inner
Lower Jet
Plate, Outer
Door
Latch
Handle
IMPORTANT NOTE :
Use of cleaning chemicals not approved by Ovention when
cleaning the oven chamber will void the warranty.