6
7
UK: INSTRUCTION MANUAL
5. CLEANING THE INJECTORS
• Fully turn off the control knobs (5) and disconnect the gas cylinder
• Remove the pot/pan grid (6) and close the lid (1)
• Turn the appliance upside down and loosen the base of the burner
• Blow through the hole to clean the injector with compressed air
• Reattach the base of the burner
• Turn over the appliance, open the lid (1) and assemble the lid (1), windshields (3) and pot/pan grid (6)
• Reconnect the gas cylinder. Check the connecting joint with warm soapy water. If bubbles are
produced the seal is not tight enough.
If you are not able to rectify any fault following the abovementioned instructions, contact the dealer
or Outwell Customer Service (contact details below).
6. HOW TO CHECK FOR LEAKS WITH SOAPY WATER
• Take a washcloth and wring up in soapy water.
• Apply a small amount of the soapy water mixture to all joints of gaseous parts.
• If there is a leak, you will be able to see it as bubbles in the soapy water.
• By detection of any leaks, stop using the appliance immediately and contact the dealer or Outwell
Customer service (contact details below).
7. STORAGE
Disconnect the gas cylinder before you store the appliance away. Keep both the appliance and cylinder
in a dry place safe from dust and dirt, and away from heat and direct sunlight.
Outwell Customer Service
e-mail: [email protected]
Tel.: +45 70 22 85 00
