Getting Started
1-4
1.2
Installing the Personality Module
The printer functions only in combination with an installed interface module,
called a Personality Module (PM).
The illustration below shows the standard PM with a serial and parallel interface.
For detailed information about your PM, see Chapter 2.
Note:
-
To avoid damage due to electrostatic discharge, do not touch the pins
or components of the PM.
-
Never attempt to install or remove a PM while the printer is switched
ON.
1. Remove the PM (16) from its packing material.
2. Insert the Personality Module (16) with the component side upwards until the
connector fully engages. Hand tighten the two lock screws (17).
Summary of Contents for CI-4070
