14
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina-B Installation Manual • 4066-500 Rev. B • 5/14
WARNING! Risk of Shock or Explosion! DO NOT
wire
110-120 VAC to the valve or to the appliance wall switch.
Incorrect wiring will damage controls.
NOTICE:
This appliance must be electrically wired
and grounded in accordance with local codes or, in the
absence of local codes, with
National Electric Code
ANSI/NFPA 70-latest edition
or the
Canadian Electric
Code CSA C22.1.
• Wire the appliance junction box to unswitched 110-
120 VAC. This is required for proper operation of the
appliance.
• A 110-120 VAC circuit for this product must be protected
with ground-fault circuit-interrupter protection in
compliance with the applicable electrical codes.
• Low voltage and 110-120 VAC voltage cannot be shared
within the same wall box.
5
5
Electrical Information
Electrical Service and Repair
WARNING! Risk of Shock!
Label all wires prior to dis-
connection when servicing controls. Wiring errors could
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock!
Replace damaged wire with
type 105º C rated wire. Wire must have high temperature
insulation.
Note:
If a gas conversion is to be done on this appliance,
it should be done before electrical connections are made.
See Section 6 Gas Information.
A. General Information
B. Wiring Requirements
IntelliFire Plus™ Pilot Ignition System Wiring
• Wire the appliance junction box to 110-120 VAC for
proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT
wire
IPI controlled appliance junction box to a switched circuit.
Incorrect wiring will override IPI safety lockout.
• This appliance is equipped with an IntelliFire Plus™
control valve which operates on a 6 volt/1.5 AMP system.
• Plug the 6 volt transformer plug into the appliance junction
box to supply power to the appliance.
• This appliance is supplied with an electric kit which is
located in the control box. A wiring diagram is shown in
Figure 8.1.
• The appliance comes standard with an OFF/ON switch
on the control box lid
• Optional RC100 wireless wall switch (OFF/ON). For use
with the electric kit.
NOTICE:
RC100 must be protected from the elements.
• The module should be in the REMOTE position. Putting
the switch in the OFF position will disable all appliance
controls.
Hearth & Home Technologies recommends that IntelliFire
Plus
TM
wireless controls be used for their features and
functionality with the IntelliFire Plus
TM
ignition system.
