Setting the Chime:
Press S3 to enter. Press S1 or S5 to select ON or OFF. Press S3 to confirm setting.
Setting ALARM:
The same procedure applies in setting the Time.
Setting the NIGHT mode:
Press S3 to enter. Press S1 or S5 to select the following options: Night ON, 10 sec & 20 sec.
10 SECONDS
– Press S11 will turn ON the Light for 10 seconds.
20 SECONDS
– Press S11 will turn ON the Light for 20 seconds.
NIGHT ON
– Light will continuously ON when GPS is ON and CHRONO is running in preset duration time (6:00 pm to 7:00
am).
Press S3 to accept the selected setting. Press S7 to exit.
Battery:
Watch is using a rechargeable Lithium Ion battery that will require approximately 4.0 hours charging time using the USB
cable. While battery is charging, the watch cannot be used. User needs to recharge the battery when the watch indicates a
“low battery”.
Note:
Battery Life
(fully charge battery);
8 hrs typical
continues run with GPS ON and CHRONO ON.
GPS watch troubleshooting guide:
PROBLEM/ QUESTION
SOLUTION/ ANSWER
How to turn off the GPS
Press and hold S9 for about 5 seconds from any view to turn
OFF the GPS.
I cannot get a GPS signal
Take your GPS watch outdoors and away from tress and tall
buildings. Remain stationary and try acquiring GPS signal again.
Be sure that the antenna is pointing towards the sky for better
signal reception.
Can I reset the watch?
You can reset the watch by pressing S1, S5, S7, and S11
together. The date and time will be reset to default values. You
can set it again manually or automatically thru GPS.
Will my data and personal
settings be lost after watch
reset?
Your data and personal settings are saved in the flash memory
and will not be lost after watch reset.
The battery indicator does not
seem to be accurate
Allow your GPS watch to fully discharge and then fully charge it
without interruption. It is recommended to regularly re-charge
your battery every 1-2 months even if it is not used to maintain
good battery condition.
