![Outbound GR-B100 Runner Series Instruction Manual Download Page 3](http://html1.mh-extra.com/html/outbound/gr-b100-runner-series/gr-b100-runner-series_instruction-manual_1660884003.webp)
2.3)
Connect the charging clip securely to the watch.
Note: Please thoroughly dry the charging contacts and surrounding area to ensure proper electrical contact and prevent
corrosion.
When the battery is low, it is time to charge the GPS watch. Once the battery is full, it will display CHARGE 100% FULL.
Battery low condition:
You cannot turn ON the GPS when the battery is low. The watch will display BATT LOW. You need to recharge the battery in
order to use the GPS again.
When the battery is almost low and you still perform your exercise, your data may not be saved if the battery becomes low.
Please make sure the battery have enough battery power before doing your exercise in order not to lose your data.
When the battery level becomes very low, the watch will automatically turn OFF the display (blank-screen).
Step 3) Configure your watch:
Before using your GPS watch, User can opt to do the following.
3.1)
Go to
SET
mode to set the following parameters:
AUTO LAP, TIME, UNIT
,
USER
details,
NIGHT, CONTRAST, CHIME
and
ALARM.
Step 4) Acquire Satellite signals:
To get the correct time of day and begin using your GPS watch, you have to acquire GPS signals. It may take few minutes to
acquire the satellite signals.
4.1)
Go outside to an open area away from tall buildings and trees. Orient the GPS antenna towards the sky for best
reception. The antenna is located at the 6 o’clock position of the watch.
Note: In order to accurately navigate the GPS, you need to have a good line of sight to the satellites.
4.2)
Stand still and do not begin moving while performing the following steps until the GPS signals are already received.
4.3) How to Turn-ON the GPS:
In Time mode, press S1 or S7 to go to RUN mode or press and hold S7 in any mode for 3
seconds to turn ON GPS, the watch will start searching or locating the satellites. After receiving the satellite signals, it
will automatically display “GPS GO”, CHRONO (00’00”00) and PACE (- -‘- -“).
Also note that the watch will display the relative signal strength on the upper side (12H position).