0
PB
The
ERROR OUTPUT
default state is
On
, meaning
12 VDC is present at the AUX terminal. If the
FLEXmax 80 has not charged the batteries for 26
hours or more continuously, the inaudible
ERROR
OUTPUT
goes into an
Off
state. The
ERROR OUTPUT
is intended for remote locations to signal (e.g., a
telecommunication signal to a computer) when the
FLEXmax 80 has not charged the battery for 26 hours
or more. Press the
<SET>
soft key to advance to the
ERROR OUTPUT
volt screen.
The
ERROR OUTPUT
screen displays the number of
hours the FLEXmax 80 has not been producing any
power (the number of hours in
Sleep Mode
). Press
the
<VOLT>
soft key to adjust the
ERROR LOW BATT
VOLTS
screen.
User-determined value—not less than 10V—will
trigger an alarm or, through a user-supplied modem,
send a signal from a remote installation indicating
the battery charge has reached this value. This
informs the user of a low battery problem. Use the
< - >
and
< + >
soft keys to change this value. Press
the
<BACK>
soft key to return to the
AUX MODE
ERROR OUTPUT
screen.
Press the
<EXIT>
soft key to bring up the original
ERROR OUTPUT
screen.
Press the
<NEXT>
soft key to view the
Night Light
screen.
AUX MODE
ERROR OUTPUT
Output: On On
EXIT NEXT SET MODE
On
Off
Auto
AUX MODE
ERROR OUTPUT
01 hrs
EXIT VOLT
ERROR LOW BATT VOLTS
<11.5
BACK - +
AUX MODE
ERROR OUTPUT
01 hrs
EXIT VOLT
ERROR OUTPUT
AUX MODE
ERROR OUTPUT
Output: On On
EXIT NEXT SET MODE
Summary of Contents for FLEXMAX 80
