Last Update: 2011-June INSTRUCTION MANUAL FOR THERMOSYPHONIC SYSTEMS
22/35
©TANSUG MAKİNA LTD. 2008
6.5 Assembly of Thermosyphonic Flat Roof Stand (TFR35)
By changing only two parts (B,C) that are listed at Section 2, you can easily convert your flat
roof structure from 45° inclination to 35°. During your installation you just need to take into
account the dimensions illustrated in Figure C, below:
6.5 Assembly of Thermosyphonic Inclined Roof Stand (TIR)
The way the inclined roof stand is assembled depends on whether you use the
components for 35° or 45° (C35 or C45) in your flat roof installations. The assembly is
very similar with a small difference which is illustrated at Figure E & F.
6.5.1
Put the base frame (A) and the side frame (C) together to form one straight frame as
seen on Figures E & F. The frames will be connected by the use of two screws
6.5.2
Put together the second leg of the structure in the same way described at step 4.3.1.
6.5.3
Connect the tank beds (F) from the outer surface of the straight frame you have obtained
by putting together parts A and C together. You can count the holes to identify the exact
location of connection. Use back diagonals (E) to connect the two frames together. The
distance between the center of tank beds must be
880 mm.
for structure type TIR45-1
FIGURE C: TFR35-1 /2:
T. Syphonic flat Roof Structure for 1-2 Panel 35°