Welding
GB
56
CPTX 400/400w/450w Synergy
7.4 Selection of the appropriate feed rolls
The feed mechanism is equipment with 4 rolls. Upon delivery rolls with V-groove with a
diameter of
1.0-1.2 mm are attached. With the change of the wire diameter you have to
replace a corresponding groove. For steel and CrNi rolls with V-groove are used. If you want
to weld with flux cored wire you have to use rolls with a U-groove.
8. Welding
Set up the device in the workplace. Pay attention primarily to the fact that the air can
circulate well and the cooling is ensured. Clip the ground wire with the clamp on the clean,
non-oxidized work part. Congenial to the material and the thickness of the work piece, the
corresponding wire diameter has to be selected. After turning the switch the welding machine
is on and welding supply. With the potentiometer you can select the needed wire speed.
Note that the handling of the torch greatly affected the welding quality (see following figures).
The distance between the wire and the work piece must be kept constant, whereat the
recommended distance for steel plates is about 5-10 mm.
Pressing the torch switch the unit starts to weld. The torch is handled by one of the three
methods shown above.
8.1 Setting of welding current
The welding current is adjusted by turning the tap changer as follows:
Turn right = increase of welding current
Turn left = decrease of welding current
Push
Position
Neutral
Position
Pull
Position
Contact
tip
