B_EU_EMP_en.doc
ÖSTLING Markiersysteme GmbH
Operation manual EMP
30
During the off periode no current flows. The stencil does not continue to heat
itself.
10. Press
↓
(5) until parameter "Off periode" appears.
11. Press ENTER (6).
12. To increase the off periode: press
↑
(4).
Each press increases the time of the off periode in steps of 0.1 s. The maxi-
mum value is 5.0 s.
13. To decrease the off periode: press
↓
(5).
Each press decreaes the time of the off periode in steps of 0.1 s. The mini-
mum value is 0.1 s.
14. To reject the settings: press MENU (7). To assume the settings: press
ENTER (6).
Menu "Mark options" appears.
If you want to shift during a pulse marking between alternating (AC) and direct
current (DC) DC/AC automatic must be ON. Only in this case the parameters
"=/~ time" and "=/~ mark power" are considered during the marking.
The marking starts with the current type that is selected with the pushbutton
AC/DC (8) (see page 26).
15. Press
↓
(5) until parameter "=/~ automatic" appears.
16. Press ENTER (6).
17. Press
↓
(5) until DC/AC automatic is ON or OFF.
18. To reject the setting: press MENU (7). To assume the setting: press ENTER
(6).
Menu "Mark options" appears.
Pulse marking with direct (DC) and alternating current (AC): Time after that the
type of current is changed.
19. Press
↓
(5) until parameter "=/~ time" appears.
20. Press ENTER (6).
21. To increase the DC/AC time: press
↑
(4).
Each press increases the DC/AC time in steps of 0.1 s. The maximum
value is 15.0 s.
22. To decrease the DC/AC time: press
↓
(5).
Each press decreases the DC/AC time in steps of 0.1 s. The minimum
value is 0.1 s.
23. To reject the settings: press MENU (7). To assume the settings: press
ENTER (6).
Menu "Mark options" appears.
Setting the
off periode
DC/AC automatic
Setting the
DC/AC time
