SECTION 3 - GENERAL ELECTRICAL INFORMATION & SCHEMATICS
3121801
– JLG Lift –
3-11
10. Push contact straight into connector grommet until a positive stop is felt. A slight tug will confirm that it is properly
locked in place.
Figure 3-15. HD/HDP Locking Contacts Into Position
NOTE:
For unused wire cavities, insert sealing plugs for full environmental sealing
HD30/HDP20 Series Disassembly
Figure 3-16. HD/HDP Contact Removal
11. With rear insert toward you, snap appropriate size extractor tool over the wire of contact to be removed.
12. Slide tool along into the insert cavity until it engages contact and resistance is felt.
13. Pull contact-wire assembly out of connector.
Figure 3-17. HD/HDP Unlocking Contacts
NOTE:
Do Not twist or insert tool at an angle.
Summary of Contents for JLG 260MRT
