Oshkosh Corporation JLG 260MRT, Service Maintenance Manual

Page: 53 / 106

SECTION 2 - PROCEDURES
3121801 – JLG Lift – 2-31
Using the Analyzer
With the machine power on and the analyzer connected
properly, the analyzer will display the following:
HELP:
PRESS ENTER
At this point, using the RIGHT and LEFT arrow keys, you
can move between the top level menu items. To select a
displayed menu item, press
ENTER. To cancel a selected
menu item, press ESC ; then you will be able to scroll
using the right and left arrow keys to select a different
menu item.
The top level menus are as follows:
HELP
DIAGNOSTICS
ACTIVATE TESTS
ACCESS LEVEL
PERSONALITIES
MACHINE SETUP
LEVEL VEHICLE
If you press ENTER , at the HELP:PRESS ENTER display,
and a fault is present during power up, the analyzer dis-
play will scroll the fault across the screen. If there was no
fault detected during power up, the display will read:
HELP: EVERYTHING OK
If ENTER is pressed again, the display moves to the fol-
lowing display:
LOGGED HELP
1: STARTUP (2/1)
At this point, the analyzer will display the current fault, if
any are present. You may scroll through the fault logs to
view what the last 15 faults were. Use the right and left
arrow keys to scroll through the fault logs. To return to the
beginning, press
ESC two times.
When a top level menu is selected, a new set of menu
items may be offered; for example:
PLATFORM
DRIVE
LIFT SEL
SPEED SEL
HORN
ENGINE START
FUEL/GLOW
STEER LEFT
STEER RIGHT
JOYSTICK
Pressing ENTER with any of the above displayed menus,
will display additional sub-menus within the selected
menu. In some cases the next level is the parameter or
information to be changed. Refer to the flow chart for what
menus are available within the top level menus. You may
only view the personality settings for selected menus
MENU:
HELP:PRESS ENTER
l og: ( 211)