CAS80R
SECTION 6: TROUBLESHOOTING
Manual # 99905932 (February 2016)
PAGE - 29
®
IOWA MOLD TOOLING CO., INC.
(641) 923-3711 • www.imt.com
6.1 GENERAL INFORMATION
The information contained in this section has
been compiled from field report data and
factory experience. It contains symptoms and
usual causes for the most common types of
problems that may occur; however,
DO NOT
assume that these are the only problems that
may occur. All available data concerning the
trouble should be systematically analyzed
before undertaking any repairs or component
replacement procedures.
A detailed visual inspection is worth
performing for almost all problems, and may
avoid unnecessary additional damage to the
machine. The procedures which can be
performed in the least amount of time and
with the least amount of removal or
disassembly of parts, should be performed
first. Always remember to:
1. Check for loose wiring.
2. Check for damaged piping.
3. Check for parts damaged by heat or an
electrical short circuit, usually noticeable
by discoloration or a burnt odor.
Should the problem persist after making the
recommended check, consult your nearest
IMT representative or the IMT Service
Department.
Iowa Mold Tooling Co., Inc.
500 Highway 18 West
Garner, Iowa 50438
Phone: 641.923.3711
Fax: 641.923.2424
WARNING
DO NOT operate the compressor or any of its
systems if there is a known unsafe condition.
Disable the equipment by disconnecting it from
its power source.
NOTE THAT THE SYSTEM CAN BE STARTED
REMOTELY:
Install a lock-out tag to identify the equipment
as inoperable to other personnel to prevent
accidental application.
WARNING
Before starting, performing maintenance, or
replacing parts, relieve the entire system
pressure by opening a service valve, which will
vent all pressure to the atmosphere.
6-1: Machine Serial Plate /Serial Number Location
SECTION 6:
TROUBLESHOOTING
Summary of Contents for IMT CAS80R
Page 66: ...BLANK PAGE...
Page 67: ...BLANK PAGE...
