4 ADJUSTMENTS
Inc. All rights reserved
24
1. Slide the tubes into each other until they reach the desired width (see Figure 9-
B).
2. Insert the screw (
A
), washers (
B
) and nut (
C
) into the centre hole and firmly
tighten (
3/8 in. wrench
and
5/32 in. hex key
).
c) Assembling the tilt mechanism handles (see Figure 9-C):
Figure 9-D: Handle assembly.
1. Remove the handles from the back support posts and reposition them on the
integrated adjustable angle push handle;
2. Using a
4 mm Allen wrench
, loosen the (2) screws (
A
) on the top part of the
handle. The two parts are now separated;
3. Reassemble the levers, firmly but not too tightly. Position the handles for ease
of use.
BACK
SUPPORT
POST