orolia.com
EdgeSync Manual rev 1 | 49
EdgeSync Alarm condition is
affecting MGMT Port Link
State.
Check the Alarms/Events Tab
Webpage for information about
any EdgeSync alarms that
might affect MGMT Port Link
State.
Safety Considerations
The following safety consideration should be used when handling and installing the EdgeSync.
•
When installing or working on the EdgeSync equipment, ESD wrist straps should be worn.
•
Use the specified power supply and ground for the EdgeSync equipment as stated in the Power
and Ground Connections section.
•
Refer to the Applying Power section when applying power to the EdgeSync equipment.
•
When rack mounting the EdgeSync equipment, use the original mounting screws provided with
the mounting bracket so that the EdgeSync case will not be damaged. Do not substitute other
mounting screws.
•
Only authorized personnel should open the EdgeSync equipment enclosure. Unauthorized
access to the EdgeSync equipment could result in equipment damage and voiding the
EdgeSync warranty.
•
Use caution when installing the GNSS antenna near, under, or around high voltage lines. The
GNSS antenna should be equipped with proper external lightning protection/grounding to
avoid equipment damage should the antenna receive a lightning strike.
•
If the EdgeSync is rack mounted, 1RU above the EdgeSync enclosure must be left unoccupied
for heat dissipation.
7.
Managed Clock Engine Overview
EdgeSync Engine Modes
The EdgeSync Managed Clock Engine can operate in four different modes. The operational mode
defines the functionality supported by the engine, EdgeSync clock behavior and its properties in
different operating conditions. The operational mode is specified upon startup and can only be changed
by restarting the engine on the Home Webpage
•
PTP Only
•
GNSS Only
•
GNSS Primary, PTP Secondary
•
PTP Primary, GNSS Secondary.
In addition to these four modes, a Slave Only mode is supported. The clock can be switched to the
Slave Only mode and back at any time and from any of above operational modes. The Slave Only mode
is selected on the PTP :: Clock Webpage.
