Ormazabal ekor.rps, General Instructions Manual

Page: 50 / 144

IG-150-EN version 04; 03/10/16
50
Unit configuration General instructions
ekor.rps
MODBUS
If the chosen option is MODBUS, the address is programmable
from the keyboard/display, entering “CHANGE SETTINGS”,
“PROG. TABLE 0”, “CONFIG. COMMUNICAC.”, “PORT COM 2”,
"CONFIG. MODBUS", “UCL ADDRESS". This address does not
need to be the same as the one of the front port, but it is
convenient to avoid confusions. The units leave the factory
with the address and the rest of the MODBUS parameters
without been programmed. They have to be programmed
by the user.
If the ekor.rps unit is replaced by another one, the installed
unit must have the same address as the one removed.
They are also programmable the baud rate, the parity and
the auxiliary timers for activation and deactivation of the RT
signal (internal).
The established communication settings can be seen on
display, entering “SEE SETTINGS”, “SEE TABLE 0”, “CONFIG.
COMMUNICAT.”, “PORT COM 2”, "CONFIGUR. MODBUS".
Apart from the keyboard/display, the settings can also be
displayed/programmed from the PC with the protection
console.
For more detail on MODBUS, see the corresponding
appendix.
IEC 870-5-101
If the chosen option is 101, the address is programmable
from the keyboard/display, entering “CHANGE SETTINGS”,
“PROG. TABLE 0”, “CONFIG. COMMUNICAT.”, “PORT COM
2”, "GENERAL”, “LINK ADDRESS” and “APPLICAT ADDRESS”.
This address does not need to be the same as the one of
the front port, but it is convenient to avoid confusions. The
units leave the factory with the address and the rest of the
101 parameters without been programmed. They have to
be programmed by the user.
If the ekor.rps unit is replaced by another one, the installed
unit must have the same address as the one removed.
They are also programmable the baud rate, the parity and
the auxiliary timers for activation and deactivation of the RT
signal (internal).
The established communication settings can be seen on
display, entering “SEE SETTINGS”, “SEE TABLE 0”, “CONFIG.
COMMUNICAT.”, “PORT COM 2”, "GENERAL"
Apart from the keyboard/display, the settings can also be
displayed/programmed from the PC.
For more detail on 101 communication, see the corresponding
appendix.
This protocol can not be used with RS485 port.
IEC 870-5-103
[2]
If the chosen option is 103, the address is programmable
from the keyboard/display, entering “CHANGE SETTINGS”,
“PROG. TABLE 0”, “CONFIG. COMMUNICAT.”, “PORT COM 2”,
“LCU ADDRESS”. This address does not need to be the same
as the one of the front port, but it is convenient to avoid
confusions. The units leave the factory with the address and
the rest of the 103 parameters without been programmed.
They have to be programmed by the user.
If the ekor.rps unit is replaced by another one, the installed
unit must have the same address as the one removed.
They are also programmable the baud rate, the parity and
the auxiliary timers for activation and deactivation of the RT
signal (internal).
The established communication settings can be seen on
display, entering “SEE SETTINGS”, “SEE TABLE 0”, “CONFIG.
COMMUNICAT.”, “PORT COM 2”.
Apart from the keyboard/display, the settings can also be
displayed/programmed from the PC.
[2]
For more detail on 103 communication, see the corresponding
Volume 2 of 2.