Installation
▌
22
2. Move the actuator to the through hole which diameter is larger, and secure the mounting holes with screws
(four pieces).
Screws
Spring washers
Mounting holes (4 places)
Positioning pin holes
(2 places)
z
When installing an actuator which cable outlet direction is rightward or leftward
This section explains based on an example when the cable outlet direction is rightward.
The figure shows the
DGM130R-AZACR
.
Be sure to install the actuator from the upper side of the mounting plate. It cannot be installed from
below the mounting plate.
1. Pass the motor cable through the through hole of the mounting plate.
Positioning pins
Screw hole machining
in a mounting plate
Through hole
Cable
Do not remove
2. Rotate the actuator by 90 degrees.
