OREC America RM98, Operating Instructions Manual, Page: 38 / 50

38
If the differential lock lever is in the [OFF] ([RELEASE] position, adjust the base of the lever to
1/16” -1/8” distance. After adjusting, tighten the lock nut securely.
\Adjustment of the safety switch:

If the engine doesn’t start, even if the adjustment lever
is all the way up
position, and the parking brake pedal
is locked, please adjust the safety switch in the
following ways:
This switch is operated when the switch tip is in the
1/8” – 1/4” range.

When the switch tip is pushed outside this range, the
engine does not start.

If you push the switch tip too much, it may cause
damage to the switch itself. Refer to the picture at left.

The safety switch is located under the right seat bracket , at t he base of cutting
height adjustment lever , and under the seat.

After adjusting the safety switch, tighten the lock nut, put the seat back to the original
position, and tighten the knob bolt.
Precautions in cold climates:

In the winter time, be sure to remove any mud and debris from the machine, and park it
on a concrete or other hard surface. Material stuck to the machine can freeze and cause
damage.

If it is on a flat area, without putting the parking brake in [LOCK], use wheel blocks to
prevent the adhesion of the brake shoe.

If you are unable to drive the machine due to freezing, do not force the machine to move
but put hot water on the affected frozen parts and wait for the ice to melt. Use caution,
as you will bear responsibility for damage caused by pushing the machine beyond its
limits.
Long-term storage of the machine:

Do not handle gasoline in the presence of lit cigarettes, open flame, or other
sources of ignition. Gasoline is an extremely flammable liquid and there is a danger
of fire and explosions.

Store the machine in a place with good ventilation, and keep it horizontally in a firm and
flat space.

When removing the fuel in the fuel tank, wait until the engine and muffler have cooled
down (approx. 5 minutes). For safety, remove the ignition key.

Do not keep fuel which has been taken out of the plastic fuel tank, and do not use fuel
which is more than 3 months old.

Put the removed hose, clips, and drain plug in the normal position.
NOTICE
1/8” – 1/4” range
A switch body is not pushed with a bolt.