![background image](http://html.mh-extra.com/html/orbitalum/rpg-4-5/rpg-4-5_operating-instructions-manual_1648245009.webp)
(18.12.17) OC_RPG_L_BA_790038762_01_EN
orbitalum tools
GmbH, D-78224 Singen, www.orbitalum.com, Tel. +49 (0) 77 31 792-0
| 9
RPG 4.5 (S), RPG 8.6
| Operating instructions
Information and safety instructions for the responsible body
DANGER
Damaged insulation!
Fatal electric shock.
[
Do not
screw any indicators or signs to the drive motor.
X
Use stickers.
DANGER
Metal dust can collect in the motor housing and cause loss of insulation!
Fatal electric shock.
X
Depending on the level of contamination, clean the machine at least once a day using the brush
supplied.
DANGER
Damaged mains plug!
Fatal electric shock.
[
Do not
use adapter plugs with ground protected electrical tools.
X
The machine connector plug must fit the socket.
DANGER
Risk of danger through the use of the machine outdoors!
Fatal electric shock.
[
Do not
use the machine outdoors.
DANGER
Danger! The electrical motor can overheat with operation in a 110 V network.
Serious injury or death.
X
Only use the machine in the specified temperature range.
DANGER
Grounded body!
Fatal electric shock.
X
Avoid contact with grounded surfaces such as tubes, heating, cookers or refrigerators.
DANGER
Loose/baggy clothing, long hair or jewelry can get caught in rotating machine parts!
Serious injury or death.
X
Wear tight-fitting clothing during work.
X
Tie up long hair to prevent it from being caught.
DANGER
Safety components that are contaminated or worn are defective!
The failure of safety components can cause physical injury.
[
Do not
misuse the cable, e.g. such as using it to suspend or carry the machine.
X
Replace defective safety components immediately and check them daily to ensure proper operation.
X
Clean and perform maintenance on the machine after each use.
X
Keep cables away from heat, oil, sharp edges and moving equipment parts.
X
Inspect the machine daily for visible signs of damage or defects, and have them repaired by a
specialist if necessary.
WARNING
Flying parts/breaking tool!
Diverse physical injuries and material damage.
[
No
damaged or deformed cutting tools (MFW) should be used.
X
Firmly clamp the tube to be machined into the clamping unit.
X
Immediately replace worn-out tools.
X
Ensure that the cutting tools are correctly fitted.
X
The inner diameter of the clamping shells must be identical to the outer diameter of the tube to
be machined. The specific inner diameter is specified on the clamping shells. The outer diam-
eter of the tube must be determined.
X
Avoid tool breakage by ensuring low (measured) infeed (max. clamping thickness: 0.05 mm)
and correct setting of speed (see chap. 9.2, p. 26).
X
Check that the tool holder (WH) and multifunctional tool (MFW) are seated firmly, and tighten if
required.
WARNING
Falling objects or tilting and bending tubes!
Irreversible crushing.
X
Wear safety shoes (in accordance with EN ISO 20345, at least S1).
X
Place sufficient supports under the tube.
X
Transport the machine as shown in chap. 7.1, p. 17.
Summary of Contents for RPG 4.5
Page 30: ......