10
6.6
Direct setting of the output voltage value between 0 and 14 V, 0-560mV, 0-28mV and T/C
Sliding switch set to OUT-V.
The key Num activates the numeric selection.
Enter the required value with the keyboard and press Enter.
To erase the entry, use the keys
←
and
→
.
6.7
Selection of the display function
The key MENU selects following operation modes – see page 14:
TARA SELECT
Tara of the Multimeter input signal to Zero
FILTER DEGREE
Selection of averaging filter from 0 to 9.
RAMP SELECT
Activates Ramps:
1
Raising Ramp with 0.5mA, 0.25V, 10mV, 0.5mV and 20 ºC steps
2
Raising Ramp with 0.1mA, 0.05V, 2mV, 0.1mV and 5 ºC steps
3
Sinking Ramp with -0.1mA, -0.05V, -2mV, -0.1mV and -5 ºC steps
4
Sinking Ramp with -0.5mA, -0.25V, -10mV, -0.5mV and -20 ºC steps
GRAPHICS
Graphics of last 128 measuring points in the Multimeter function of the voltage
range up to 200V DC or currents up to 100mA DC.
BACKLIGHT
Back ground light: OFF or ON. With ON selection the display remains illuminated
for 20 seconds after pressing any key of the keypad.
VOLTAGE OUTPUT U
Output Signal selection
1
Output 0…14V
2
Output 0…560mV
3
Output 0…28mV
4
Thermocouples Simulation
THERMOCOUPLE OUTPUT
(Select 4 is activated)
1
Type B
2
Type E
3
Type J
4
Type K
5
Type N
6
Type R
7
Type S
8
Type T
Cold Junct. Comp.
Cold Junction Compensation can be activated or switched-off.
Unit Selection
ºC or ºF
EEprom Archive
Erase or Store the settings in internal EEPROM.
The key Esc terminates the programming mode and the display switches into the Measuring mode.
Summary of Contents for OC502-t
Page 2: ...2 ...
