Orban OPTIMOD-FM 8600, Operating Manual

Page: 318 / 397

6-6
TECHNICAL DATA ORBAN MODEL 8600
Remote Control (GPI) Interface
Configuration: Eight (8) inputs, opto-isolated and floating.
Voltage: 6 - 15V AC or DC, momentary or continuous. 9VDC provided to facilitate use with
contact closure.
Connector: DB-25 male, EMI-suppressed.
Control: User-programmable for any eight of user presets, factory presets, bypass, test
tone, stereo or mono modes, analog input, digital input.
Filtering: RFI filtered.
Tally Outputs (x2)
Configuration: NPN open-collector
Maximum Voltage: 30 VDC positive. Protected against reverse polarity by a diode; do not
exceed 50 mA through this protection diode.
Maximum Current: 30 mA; current must be limited externally.
Power
Voltage: 100–132 VAC or 200–264 VAC, switch-selected on the rear panel, 50–60 Hz, 50
VA. 8600J version for 90-117 VAC.
Connector: IEC, EMI-suppressed. Detachable 3-wire power cord supplied.
Grounding: Circuit ground is independent of chassis ground’ can be isolated or connected
with a rear panel switch.
Safety Standards: ETL listed to UL standards, CE marked.
Physical and Environmental
Dimensions (W x H x D): 19” x 5.25” x 15.5” / 48.3 cm x 8.9 cm x 39.4 cm. Depth shown
indicates rack penetration; overall front-to-back depth is 17.75” / 45.1 cm. Three rack
units high.
Display: 5.7” / 14.4 cm (diagonal) quarter-VGA color display.
Operating Temperature: 32
°
to 122
°
F / 0
°
to 50
°
C for all operating voltage ranges.
Humidity: 0–95% RH, non-condensing.
RFI / EMI: Tested according to Cenelec procedures.
Shipping Weight: 40 lbs. / 18.1 kg
Warranty
Five Years, Parts and Service: Subject to the limitations set forth in Orban’s Standard
Warranty Agreement (page 1-30).
Because engineering improvements are ongoing, specifications are subject to change with-
out notice.
Circuit Description
This section provides a detailed description of user-serviceable circuits used in the
8600. We do not provide detailed descriptions of the digital circuitry because most
of this is built with surface-mount components that cannot be removed or replaced
with typical tools available in the field. Field repair ordinarily consists of swapping
entire PC boards.