Orban OPTIMOD-FM 5700i, Operating Manual

Page: 82 / 335

2-26
INSTALLATION ORBAN MODEL
signal is unusable.
•
When pilot sync is specified (
S
ETUP
> I/O C
ALIB
> D
IG
O
UT
C
ALIB
> DO S
YNC
) and
such an error is detected, the 5700i automatically switches the sync source to
the digital input.
•
If there is no valid digital input signal at the digital input, the sync source de-
faults to the 5700i’s internal clock.
•
No Function : Tally output is disabled.
C) Program tally output #2 if you wish, following the procedure in step (B) above
with the
T
ALLY
O
UT
2 button.
The following material provides detailed instructions on how to set up the 5700i. If
QUICK SETUP does not fully address your setup needs or if you wish to customize
your system beyond those provided with QUICK SETUP, then you may need the addi-
tional information in the sections below. However, for most users, this material is
only for reference because QUICK SETUP has enabled them to set up the 5700i cor-
rectly.
Analog and Digital I/O Setup
For the following adjustments, use the appropriately labeled soft button to choose
the parameter to be adjusted. To change a parameter (like an output level), it is usu-
ally necessary to hold down the soft button while turning the knob.
1. Temporarily set the external AGC mode to “No.”
A) Navigate to
Setup > Next > Next > E
XT
AGC
and set
E
XT
AGC
to
N
O
. (It may be
set to N
O
already.)
If you are using a external AGC like the Orban 6300, you should restore
this setting to
Y
ES
after the setup procedure is complete.
2. Adjust Input selector.
A) Navigate to
Setup > I/O C
ALIB
> A
NLG
I
N
C
ALIB
> I
NPUT
.
B) Set the
I
NPUT
to
A
NALOG
.
The 5700i will automatically switch to analog input if signal lock is un-
available at the AES3 input.
3. Adjust Analog Input Reference Level.
[
−
9 dBu to +13 dBu (VU), or –1 to +21 dBu (PPM)] in 0.5 dB steps