6.
Make sure the clip nuts are parallel (in the identical mounting hole).
Prepare the Expansion Module by Removing the Cartridge Magazines
Remove the cartridge magazines to access the mounting holes of the Expansion
Module.
Figure 2-15 Magazine Latches
Illustration Legend:
1 - Module Flanges
2 - Unlatched Position
3 - Latched Position
1.
Remove the Expansion Module from the shipping container.
See
Unpack and Acclimate the Library
.
2.
Reach behind the front panel and lift the latch to release the magazine.
The Expansion Module is open at the top, and the latches are located behind the
front face of the module.
Tip:
You can also release the magazine with the hex tool . See
Cartridge Magazine with the Hex Key
.
3.
Remove and set aside the cartridge magazines.
Install the Floor in the Bottom Expansion Module
Install the floor on the module that will reside at the bottom of the library.
Only perform this procedure for the bottom module. It is easiest to install the floor
before mounting the bottom module into the rack.
1.
Turn the module over.
2.
Orient the floor so the finger holds are facing the inside of the cartridge magazine
slot (see
Chapter 2
Install the Expansion Module
2-19