Illustration Legend:
1 - Front Tab
2 - Center Tab
3 - Bottom Tab
4 - Rear Tab
1.
Grasp the module along the sides and lift the back above the rack rails. Never lift
the module by the front control panel or the tape drive. Always lift the module from
the side.
2.
Guide the module into the rack and set the rear side-tabs on the rack rails (see
figure above).
Note:
If the module does not fit properly, remove it from the rack. Adjust the rail
spacing as necessary. Never bend the Base Module side tabs.
3.
Push the module into the rack to engage the bottom and center side tabs.
4.
Push the module into the rack until the front side-tabs approach the front of the
rack rails.
5.
Lift the module up slightly, push it into the rack, and set the front tabs down on the
rack rail.
Remove the Cartridge Magazine with the Hex Key
A specialized hex key tool allows you to remove the cartridge magazine.
1.
Insert the hex key in the hole at the lower inside corner of the cartridge magazine.
2.
Align the hex key shaft parallel with the magazine face.
3.
Push the tool slowly into the hole to release the latch located behind the touch
screen, and hold the hex key in place.
Chapter 2
Install the Base Module
2-13
