2
♦ ♦ ♦ C H A P T E R 2
Hardware Installation and Removal
This chapter describes how to install and remove the Converged Network Adapter (adapter).
Refer to your system installation or service manual for detailed instructions.
This chapter contains the following topics:
■
“Observing ESD and Handling Precautions” on page 21
■
“Installing the Hardware” on page 22
■
“Converged Network Adapter LEDs” on page 26
■
“Testing the Installation” on page 28
■
■
“Updating the Multi-Boot Code” on page 37
■
“Removing the Hardware” on page 38
Observing ESD and Handling Precautions
Caution -
Damage to the Converged Network Adapter can occur as the result of careless
handling or electrostatic discharge (ESD). Always handle the adapter with care to avoid damage
to electrostatic sensitive components.
To minimize the possibility of ESD-related damage, use both a workstation antistatic mat and
an ESD wrist strap. You can get an ESD wrist strap from any reputable electronics store or
from Oracle as part number 250-1007. Observe the following precautions to avoid ESD-related
problems:
■
Leave the adapter in its antistatic bag until you are ready to install it in the system.
■
Always use a properly fitted and grounded wrist strap or other suitable ESD protection
when handling the adapter and observe proper ESD grounding techniques.
■
Hold the adapter by the edge of the board, not the connectors.
Chapter 2 • Hardware Installation and Removal
21
Summary of Contents for SG-EMFCOE2-Q-SR
Page 2: ......
