Removing the Hardware
{0} ok
boot /pci@7c0/pci@0/pci@9/ethernet@0 -v
Multi-Boot Code Update Utilities
You can update the multi-boot code using the QLogic command-line interface (CLI) utility.
This utility is located on the Oracle support area of the QLogic web site:
http://driverdownloads.qlogic.com/QLogicDriverDownloads_UI/Oracle_Search.aspx
Before updating the multi-boot code, install the latest Oracle Solaris Converged Network
Adapter driver. Then copy the multi-boot binary file
Q8Qxxyyy.BIN
from the preceding link to
the Oracle SPARC system under the
root(/)
directory.
For procedures on updating multi-boot and MPI tables using the QLogic utility, refer to the
QLogic CLI user's guide.
Removing the Hardware
The following instructions describe how to remove the Converged Network Adapter, in the
event that you need to do so. Refer to your system installation or service manual for detailed
adapter removal instructions.
The following steps summarize the hardware removal process:
1. Prepare the adapter for hot-plug removal with one of the following:
■
The adapter Attention (ATTN) button
■
The Oracle Solaris OS
2. Remove the adapter hardware.
To Prepare the Adapter for Removal Using the
Adapter Attention Button
1.
Press and release the Attention (ATTN) button near the bottom of the adapter
front panel.
The Attention LED near the button will blink for approximately five seconds, indicating that the
adapter is being prepared for removal.
38
Sun Storage 10 GbE FCoE ExpressModule Converged Network Adapter From QLogic Installation Guide For Adapter
Models SG-EMFCOE2-Q-SR, SG-XEMFCOE2-Q-SR, SG-EMFCOE2-Q-TA, SG-XEMFCOE2-Q-TA, and 7101682 •
January 2017
Summary of Contents for SG-EMFCOE2-Q-SR
Page 2: ......
