To Connect the Copper Cables
2.
Connect the other end of the cable, or cables, to the FCoE switch.
Note -
Link Aggregation Control Protocol (LACP) cannot be used on the same port as FCoE or
iSCSI.
To Connect the Copper Cables
Use only SFP+ direct attach twinax cables approved by Oracle. The following table lists the
part numbers for the approved twinax copper cables.
Brocade Part Number
Oracle Part Number
Cable Description
SN-TWX-0101
SG-XSWBROSFP-1MIPK
Brocade Twinax, 1 Meter, 1 Pack, SN
SN-TWX-0301
SG-XSWBROSFP-3M1PK
Brocade Twinax, 3 Meter, 1 Pack, SN
SN-TWX-0501
SG-XSWBROSFP-5M1PK
Brocade Twinax, 5 Meter, 1 Pack, SN
Note -
If you are connecting this Converged Network Adapter to a Cisco FCoE switch, do not
use the cables listed in this section. Instead, use OM-3 twin-ax cables that are supported by
Cisco. Check with Cisco for the recommended twin-ax cables to use with the specific Cisco
switch that you are using. If any issues occur due to the use of Cisco cables, contact Cisco
support for resolution.
1.
Insert one end of the copper cable, or cables, into an empty SFP+ cage on the
adapter.
Confirm that the cable is fully inserted and engaged.
Chapter 2 • Hardware Installation and Removal
25
Summary of Contents for SG-EMFCOE2-Q-SR
Page 2: ......
