Oracle Netra Server X3-2, Installation Manual

Page: 111 / 126

Powering On the Server the First Time 103
6. Connect the power wiring to the server by plugging each power cable into the
server power supply units.
7. When you are ready to apply power, energize the input cables and verify that
the green DC input LED is illuminated on each power supply.
Power is immediately supplied to the SP, and the front panel SP OK/Fault LED
flashes (see
“Front Panel Components (Installation)” on page 5 ). The SP then runs
diagnostics and initializes the Oracle ILOM firmware.
After the Oracle ILOM firmware initializes, the SP OK/Fault LED remains lit, the
main power OK/Fault LED slowly flashes, and the SP login prompt displays on
the terminal device. However, the host is not initialized or powered on yet.
8. Power on the server.
See “Power On the Host for the First Time” on page 103 .
Related Information
■
“Connect the Chassis Ground Wire” on page 94
■
“Assemble the DC Input Power Cord” on page 95
■
“Install Strain Relief Housings” on page 99
■
“Power On the Host for the First Time” on page 103
▼
Power On the Host for the First Time
This procedure explains how to access and power on the host through the SER MGT
port using the Oracle ILOM CLI.
1. Ensure that these conditions are met:
a. A terminal device is connected to the SER MGT port. See “Cable the SP” on
page 81 .
b. Power is applied to the server. See “Powering On the Server the First Time” on
page 91
2. Press Enter on the terminal device to establish a connection between the
terminal device and the Oracle ILOM SP.