Oracle Netra Server X3-2, Installation Manual

Page: 107 / 126

Powering On the Server the First Time 99
Note – If you need to remove a wire from the DC input plug, insert the cage clamp
operating lever or a small screwdriver and pull the wire from the DC input plug.
8. Release the lever or remove the tool to secure the wire into the connector.
9. Repeat the procedures for the other two wires to complete the assembly of the
DC input power cable.
10. Repeat this procedure to create as many DC input power cables as you need for
your unit.
11. Install strain relief housings.
See “Install Strain Relief Housings” on page 99 .
Related Information
■
“Connect the Chassis Ground Wire” on page 94
■
“Install Strain Relief Housings” on page 99
■
“Connect DC Power Cords” on page 102
■
“Power On the Host for the First Time” on page 103
▼
Install Strain Relief Housings
1. Ensure that you have connected the chassis ground wire and assembled the DC
input power cords.
See “Connect the Chassis Ground Wire” on page 94 and “Assemble the DC Input
Power Cord” on page 95 .
2. Insert the bottom portion of the strain relief housing into the notch on the DC
input plug until it snaps into place.
Ensure that the strain relief housing snaps into place on the DC input plug. You
cannot complete the assembly correctly if the strain relief housing is not snapped
into place.
3 From chassis ground (green/yellow)
4 From -48V or -60V
No. Description