2.
With the heads of the five chassis locating pins protruding through the five keyhole
openings in the mounting bracket, pull the mounting bracket toward the front of the
chassis until the mounting bracket clip locks into place with an audible click.
3.
Verify that the rear locating pin has engaged the mounting bracket clip.
4.
To install the other mounting bracket on the other side of the chassis, repeat steps
1 through 3.
Installing the Slide Rails into the Rack for an Oracle ZFS
Storage ZS5-4 Controller
Use the following procedure to install the slide rails into the rack for an Oracle ZFS
Storage ZS5-4 controller.
If you plan to move the rack after the controller is installed, use mounting screws and
cage nuts to secure the slide-rail assembly. Refer to Rail Rackmount Kit Overview and
Information card for instructions on inserting these cage nuts. This card is included
with the rack kit.
1.
Position a slide-rail assembly in your rack so that the slide-rail assembly front
bracket is on the outside of the front rack post and the slide-rail assembly rear
bracket is on the inside of the rear rack post.
2.
Align the slide-rail assembly mounting pins with the front and rear rack post
mounting holes. Then lock the assembly into place by pushing the assembly
toward the rear of the rack until the mounting pins engage the rack with an audible
click.
Chapter 6
Installing the Slide Rails into the Rack for an Oracle ZFS Storage ZS5-4 Controller
6-2
