Testing the Installation
Testing the Installation
This section contains the following topics:
■
“To Verify Proper Installation (Oracle Solaris)” on page 28
■
“To Verify Attached Storage (Oracle Solaris)” on page 28
To Verify Proper Installation (Oracle Solaris)
1.
Use the
cfgadm
command to verify proper HBA installation.
cfgadm
If the HBA is properly installed and connected, you will see output similar to the following:
Ap_Id Type Receptacle Occupant Condition
c1 fc connected configured ok
c2 fc connected configured ok
pcie1 pci-pci/hp connected configured ok
2.
If an HBA is shown as unconfigured or disconnected, use the
cfgadm
‐
c
configure
command to configure the HBA.
To Verify Attached Storage (Oracle Solaris)
1.
Use the
cfgadm -al
command to verify attached storage.
cfgadm -al
If the HBA is properly installed and storage is connected properly, you will see output similar
to the following example. In this example, one port of an HBA is connected through a fabric
switch to two ports of a disk array.
Ap_Id Type Receptacle Occupant Condition
c1 fc-fabric connected configured unknown
c1::200600a0b816005e disk connected configured unknown
c1::200700a0b816005e disk connected configured unknown
28
StorageTek Dual 8Gb FC Dual GbE HBA, ExpressModule, Emulex Installation Guide For HBA Models SG-
XPCIEFCGBE-E8-Z, SG-PCIEFCGBE-E8-Z, SG-XPCIEFCGBE-E8-N, SG-PCIEFCGBE-E8-N and 7105393 • August
2018
