18
6.
To adjust the flow/pressure of the water pump: a plastic screw can be found in the cupboard
underneath the sink unit, on the back of the female pump connector. Turn clockwise to increase
flow/pressure and anti-clockwise to reduce flow/pressure.
7.
To operate the pump, simply lift up the tap lever in the sink. The inlet socket has a pressure
switch that automatically operates the pump when the tap is opened. It may take a few seconds
for the water to run steady - due to air in the pipes.
8.
When packing away the OPUS
®
you must adhere to the following procedure in order to drain
the system of any excess water before disconnecting the internal water inlet and internal waste
pipe:
Switch off the pump at the mains power switch.
Open the tap and allow the excess water in the pipe to drain.
Close the tap once all of the water has drained.
Disconnect either side of the male to male hose coupler.
Disconnect the bottom waste water outlet pipe.
The waste water outlet pipe can be secured underneath the sink unit.
The male to male hose coupler can be left on either of the hoses when disconnected.
Store the external submersible pump and external waste pipe fitting inside the sink.
Close the glass lid.
IMPORTANT! A SMALL AMOUNT OF WATER MAY BE PRESENT FROM THE CONNECTORS
AND WASTE HOSE, SO A CLOTH IS USEFUL TO REMOVE ANY EXCESS WATER.
A.
B.
C.
D.
E.
F.
G.
H.
I.
8.A
8.B
8.C
8.D
8.E
8.F
8.G
8.H
8.I
