opto engineering LTDVE1CH-40F, Instruction Manual

Page: 54 / 77

53
Firmware version 1.10 - Document version 1.06 - eng
LTDVE1CH-40F | INSTRUCTIONS MANUAL
•
Setup light outputs
•
Setup synch outputs
•
General setup
•
Advanced setup
In the bottom part of the main page, the following information is collected:
•
Version information :
o
Device type : model of the controller
o
Bootloader firmware version : version of the MCU bootloader firmware
o
MCU firmware version : version of the MCU application firmware
o
FPGA firmware version : version of the FPGA firmware
o
Board version : version of the hardware board
•
Current state :
o
Converter temperature : temperature of the DC step-up converter
o
Driver temperature : average temperature of the internal drivers
o
Remote temperature : temperature measured by remote sensor, if present
o
Supply voltage : actual supply voltage of the controller
o
Supply current : actual current drawn by the DC/DC converter
o
Converter output voltage : actual voltage output from the DC/DC converter
o
Converter output current : actual current output from the DC/DC converter
o
Driver voltage : actual voltage supplying the output drivers for the lights
o
Measured current LD : measured current on light output LD
o
Measured voltage LD : measured voltage on light output LD
If the remote temperature sensor is not connected, the indication N/A, standing for Not Available, is
displayed in the web page.
Light current and voltage are measured continuously when the output is active. Light current and
voltage stop being updated when the output turns off. If a measurement is not available, the
indication N/A, standing for Not Available, is displayed in the web page.
14.3.2. Setup synch inputs
This page allows to inspect and change all the settings related to the synchronization input. The
Setup synch inputs page is shown in the image of Figure 13: the Setup synch inputs web page .