opto engineering LTDVE1CH-40F, Instruction Manual

Page: 61 / 77

60
Firmware version 1.10 - Document version 1.06 - eng
LTDVE1CH-40F | INSTRUCTIONS MANUAL
Figure 18: the Advanced setup web page
The fields under Change unlock password can be used to set or modify the password employed
to protect the settings of the controller from unauthorized modify.
•
Current password is the current password (leave blank if there is not current password)
•
New password is the new password to be used
•
Repeat password is the new password to be used, repeated for safety
Maximum length for the password is eight characters. The password is cleared when the settings
are reset to the factory settings using the INIT button (see
chapter 11 for a description of the INIT
button functionalities).
The fields under Read Modbus register can be used to read the Modbus register file.
•
Address is the address of the register to be read (decimal number)
•
Value reports the contents of the register specified by the address (decimal number)
The fields under Write Modbus register can be used to write the Modbus register file.
•
Address is the address of the register to be written (decimal number)
•
Value contains the value that has to be written to the register specified by the address
(decimal number)
Please refer to chapter 14.2 for a comprehensive list of the Modbus registers available.
15. Operation with FabImage
FabImage Studio is a data-flow programming integrated development environment for machine