27
11
Water pump, water feed
line or water tank
becomes hot.
1) Water or steam in the vessel traveled backwards into the
water tank due to damaged non-return valves.
2) Steam comes out continuously from air purge valve into
water tank.
1) Clean or replace the non-return valves.
2) Detach the air purge from the pipe line and clean it or check /
replace thermistor.
12
Water or steam is
leaking from underneath
the machine.
1) Y-strainer has cracked due to freezing weather condition.
2) Safety valve bursts open due to overpressure in the vessel.
1) Thaw the machine at room temperature. Inspect it for
additional damages. Replace the damaged part(s) if any.
(See "Freeze Prevention" on page 13)
2) If the safety valve bursts at below 8.5 bar (123.2 psi), replace
the safety valve.
If the safety valve bursts at over 8.5 bar (123.2 psi), contact your
distributor.
13
Static electricity on the
spray gun or the
machine.
The machine is not grounded properly. .
Ensure that the machine is grounded using the grounding chain
located at the rear bottom of the machine.