Opticon
PHL 8000 series
User Manual
12
Standard Description
17 V1.2.1
(2002-08)
(ERM); ElectroMagnetic Compatibility (EMC) standard for
radio equipment and services; Part 17: Specific conditions for
2,4 GHz wideband transmission systems and 5 GHz high
performance RLAN equipment
EN 301 489-7
V1.2.1: (2002-
08)
ElectroMagnetic compatibility and Radio spectrum Matters
(ERM); ElectroMagnetic Compatibility (EMC) standard for
radio equipment ad services; Part 7: Specific conditions for
mobile and portable radio and ancillary equipment of digital
cellular radio telecommunications systems (GSM and DCS).
This device is a 2.4 GHz wideband transmission system (transceiver), intended
for use in all EU member states and EFTA countries, except in France and Italy,
where restrictive use applies.
In Italy the end-user should apply for a license at the national spectrum authorities
in order to obtain authorization to use the device for setting up outdoor radio links
and/or for supplying public access to telecommunications and/or network
services.
This device may not be used for setting up outdoor radio links in France and in
some areas the RF output power may be limited to 10 mW EIRP in the frequency
range of 2454–2483.5 MHz. For detailed information, the end-user should contact
the national spectrum authority in France.
1.5. Federal Communication Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
Summary of Contents for PHL 8000 series
Page 22: ...Opticon PHL 8000 series User Manual 22 2 1 2 PHL 8200 Figure 2 6 PHL 8200 overview ...
Page 75: ...Opticon PHL 8000 series User Manual 75 Figure 3 80 Owner Properties Network ID ...
Page 81: ...Opticon PHL 8000 series User Manual 81 Figure 3 90 Regional and Language Settings Input ...
Page 84: ...Opticon PHL 8000 series User Manual 84 Figure 3 94 Stylus Properties Calibration ...
