INITIAL ASSEMBLY
13
STEP 4:
Loosen quick release and lift
bike off of the mount. Support
the bike to prevent it from
falling.
STEP 5:
Keep the fork raised off the
ground and install the front
wheel. The rotor must be on
the left side of the bike and
should slide cleanly into the
caliper and between the break
pads as shown.
STEP 6:
The axle should sit in the fork
mounts. Tighten the nut on
the skewer so that the quick-
release lever is tight when
fully clamped. The lever
should point up or back when
secured. Skip steps 7-10.
STEP 7:
Steps 7-9 are for bikes with
20mm front axles.
Release the latch and open
the fork mount as shown. Lift
the bike off the mount
Support the bike to prevent it
from falling.
